Hvordan stiller man inn hysteresen til aktuatoren?
Setting the hysteresis allows the actuator to better match PID closed-loop control applications. Steps to Set the Hysteresis: Turn the S-A switch (highlighted in the red box below) to position 2.
Hvordan styre DCL-aktuatoren via modbus med vaTestTool_DCL.exe
1.Open vaTestTool_DCL-v1.31.exe. 2.The application will popup a “Connect to” dialog to set the target device id and local computer RS232 port parameters as follow. Choose the COM port which connected to
Hvordan kalibrerer jeg inngangssignalet til aktuatoren?
When the actuator’s valve position does not match the 4–20mA input signal (resulting in a discrepancy between the feedback signal and the input signal), you can calibrate the input signal to
Hvordan konfigurerer man ON-OFF-aktuatorer med posisjonsgiver?
1. Mechanical Installation 1. Mechanical Installation Refer to the “How to Install the Actuator onto the Valve” section to correctly install the actuator onto the valve and manually operate it to
Hvordan sette opp en modulerende elektrisk ventil?
1. Installing the Actuator onto the Valve Follow the installation instructions in “How to Install the Actuator onto the Valve” to correctly install the actuator on the valve. Confirm normal operation
Hvordan sette opp en elektrisk ON-OFF-ventil?
1. Adjusting the Fine-Tuning Electrical Limit Full Close Adjustment: Use the handle to drive the valve to the fully closed position. Loosen the scale plate locking screw and adjust the scale
Hvordan monteres aktuatoren på ventilen?
Installation Steps Manually rotate the valve to check for any abnormalities and ensure the valve is in the fully closed position. Secure the mounting bracket onto the valve. Fit one end
