Compare parameters between DCL explosion-proof actuators
| Model | Swing Angle | Torque/Operating Time | Duty Type | Supply Voltage | Input/Output Signal | Additional Option |
|---|---|---|---|---|---|---|
| DCL-Ex05 | 0 - 360 ° | 50Nm/20S Optional with 20Nm/4S 30Nm/10S 50Nm/60S | ON - OFF Modulating Inching - Positioning | DC24V AC24V AC110V AC220V AC380V | 4-20mA 0-10V IO Interface Optional with field bus Modbus-RTU Modbus-ASCII CAN Ethernet | Over torque protection Fail Safe Return Dehumidification Field Bus |
| DCL-Ex10 | 0 - 90 ° | 100Nm/30S Optional with 50Nm/15S 100Nm/60S | ON - OFF Modulating Inching - Positioning | DC24V AC24V AC110V AC220V AC380V | 4-20mA 0-10V IO Interface Optional with field bus Modbus-RTU Modbus-ASCII CAN Ethernet | Over torque protection Fail Safe Return Dehumidification Field Bus |
| DCL-Ex20 | 0 - 90 ° | 200Nm/30S Optional with 100Nm/15S 200Nm/60S | ON - OFF Modulating Inching - Positioning | DC24V AC110V AC220V AC380V | 4-20mA 0-10V IO Interface Optional with field bus Modbus-RTU Modbus-ASCII CAN Ethernet | Over torque protection Fail Safe Return Dehumidification Field Bus |
| DCL-Ex40 | 0 - 90 ° | 400Nm/30S Optional with 200Nm/15S 400Nm/60S | ON - OFF Modulating Inching - Positioning | DC24V AC110V AC220V AC380V | 4-20mA 0-10V IO Interface Optional with field bus Modbus-RTU Modbus-ASCII CAN Ethernet | Over torque protection Fail Safe Return Dehumidification Field Bus |
| DCL-Ex60 | 0 - 90 ° | 600Nm/45S | ON - OFF Modulating Inching - Positioning | DC24V AC110V AC220V AC380V | 4-20mA 0-10V IO Interface Optional with field bus Modbus-RTU Modbus-ASCII CAN Ethernet | Over torque protection Fail Safe Return Dehumidification Field Bus |
Recommend actuator to drive a butterfly valve
Recommend actuator to drive a Ball valve
Recommend actuator to drive a ventilation valve
Recommend valve to be driven by DCL explosion-proof actuator
Note: The recommendations in the above table is for reference only in common application scenario, the specific torque needed to drive the valve is depended up on the real application case.
It is recommended to choose an actuator with 1.1-1.3 times of torque than the value that was finalized after evaluation of torque requirement of valve and liquid pressure in the pipe. This would improve the robust performance in most worst case.
