Aktüatörün Histerezisi Nasıl Ayarlanır?

Setting the hysteresis allows the actuator to better match PID closed-loop control applications. Steps to Set the Hysteresis: Turn the S-A switch (highlighted in the red box below) to position 2. Rotate the adjustment knob (highlighted in the yellow box) to set the hysteresis. Each scale mark represents 0.5%. The adjustable hysteresis range is 0.5% […]

vaTestTool_DCL.exe kullanarak Modbus üzerinden DCL aktüatörünü nasıl kontrol edebilirim?

1. vaTestTool_DCL-v1.31.exe dosyasını açın. 2. Uygulama, hedef cihaz kimliğini ve yerel bilgisayar RS232 port parametrelerini aşağıdaki gibi ayarlamak için bir "Bağlan" iletişim kutusu açacaktır. USB-RS485 konektörüne bağlı COM portunu seçin. Modbus baud hızını seçin (DCL aktüatöründeki varsayılan baud hızı şu anda 9600'dür). Bağlanmak için "BAĞLAN" düğmesine tıklayın. […]

Aktüatörün giriş sinyali nasıl kalibre edilir?

When the actuator’s valve position does not match the 4–20mA input signal (resulting in a discrepancy between the feedback signal and the input signal), you can calibrate the input signal to eliminate this deviation. 6 Simple Steps for Calibration: Turn the S-A switch to position 2. Press and hold the Set button until the L2 […]

Konum Vericili Açma/Kapama Aktüatörleri Nasıl Yapılandırılır?

1. Mechanical Installation 1. Mechanical Installation Refer to the “How to Install the Actuator onto the Valve” section to correctly install the actuator onto the valve and manually operate it to confirm proper functioning. Follow the guidelines in “How to Set the ON-OFF Electric Valve” to properly adjust the actuator’s electrical limits (close limit CLS […]

How to Set Up a Modulating Electric Valve?

1. Installing the Actuator onto the Valve Follow the installation instructions in “How to Install the Actuator onto the Valve” to correctly install the actuator on the valve. Confirm normal operation by manually testing the valve movement. 2. Adjusting the Mechanical Limits for Fully Closed Position Use the handwheel to move the valve to the […]

How to Set Up an ON-OFF Electric Valve?

1. Adjusting the Fine-Tuning Electrical Limit Full Close Adjustment: Use the handle to drive the valve to the fully closed position. Loosen the scale plate locking screw and adjust the scale plate so that the pointer aligns with the 0 mark (SHUT direction). Then, tighten the screw. Using a 2mm hex wrench, turn the closing […]

How to install the actuator onto the valve?

Installation Steps Manually rotate the valve to check for any abnormalities and ensure the valve is in the fully closed position. Secure the mounting bracket onto the valve. Fit one end of the coupling onto the valve stem. Manually drive the electric actuator to the fully closed position (pointer aligned with SHUT or zero-degree marking) […]