Bagaimana Cara Mengatur Histeresis Aktuator?

Setting the hysteresis allows the actuator to better match PID closed-loop control applications. Steps to Set the Hysteresis: Turn the S-A switch (highlighted in the red box below) to position 2. Rotate the adjustment knob (highlighted in the yellow box) to set the hysteresis. Each scale mark represents 0.5%. The adjustable hysteresis range is 0.5% […]

Cara mengontrol aktuator DCL melalui Modbus menggunakan vaTestTool_DCL.exe

1. Buka vaTestTool_DCL-v1.31.exe. 2. Aplikasi akan menampilkan dialog “Hubungkan ke” untuk mengatur ID perangkat target dan parameter port RS232 komputer lokal sebagai berikut. Pilih port COM yang terhubung ke konektor USB-RS485. Pilih kecepatan baud Modbus (kecepatan baud default pada aktuator DCL saat ini adalah 9600). Klik tombol “HUBUNGKAN” untuk terhubung ke […]

Bagaimana cara mengkalibrasi sinyal input aktuator?

When the actuator’s valve position does not match the 4–20mA input signal (resulting in a discrepancy between the feedback signal and the input signal), you can calibrate the input signal to eliminate this deviation. 6 Simple Steps for Calibration: Turn the S-A switch to position 2. Press and hold the Set button until the L2 […]

Bagaimana Cara Mengonfigurasi Aktuator ON-OFF dengan Transmiter Posisi?

1. Mechanical Installation 1. Mechanical Installation Refer to the “How to Install the Actuator onto the Valve” section to correctly install the actuator onto the valve and manually operate it to confirm proper functioning. Follow the guidelines in “How to Set the ON-OFF Electric Valve” to properly adjust the actuator’s electrical limits (close limit CLS […]

Bagaimana Cara Memasang Katup Listrik Modulasi?

1. Installing the Actuator onto the Valve Follow the installation instructions in “How to Install the Actuator onto the Valve” to correctly install the actuator on the valve. Confirm normal operation by manually testing the valve movement. 2. Adjusting the Mechanical Limits for Fully Closed Position Use the handwheel to move the valve to the […]

Bagaimana Cara Memasang Katup Listrik ON-OFF?

1. Adjusting the Fine-Tuning Electrical Limit Full Close Adjustment: Use the handle to drive the valve to the fully closed position. Loosen the scale plate locking screw and adjust the scale plate so that the pointer aligns with the 0 mark (SHUT direction). Then, tighten the screw. Using a 2mm hex wrench, turn the closing […]

Bagaimana cara memasang aktuator ke katup?

Installation Steps Manually rotate the valve to check for any abnormalities and ensure the valve is in the fully closed position. Secure the mounting bracket onto the valve. Fit one end of the coupling onto the valve stem. Manually drive the electric actuator to the fully closed position (pointer aligned with SHUT or zero-degree marking) […]