Miten asetetaan toimilaitteen hystereesi?
Setting the hysteresis allows the actuator to better match PID closed-loop control applications. Steps to Set the Hysteresis: Turn the S-A switch (highlighted in the red box below) to position 2.
Miten DCL-toimilaitetta ohjataan modbussin kautta vaTestTool_DCL.exe:llä?
1.Open vaTestTool_DCL-v1.31.exe. 2.The application will popup a “Connect to” dialog to set the target device id and local computer RS232 port parameters as follow. Choose the COM port which connected to
Miten toimilaitteen tulosignaali kalibroidaan?
When the actuator’s valve position does not match the 4–20mA input signal (resulting in a discrepancy between the feedback signal and the input signal), you can calibrate the input signal to
Miten konfiguroida ON-OFF-toimilaitteet asentolähettimen kanssa?
1. Mechanical Installation 1. Mechanical Installation Refer to the “How to Install the Actuator onto the Valve” section to correctly install the actuator onto the valve and manually operate it to
Miten moduloiva sähköventtiili asennetaan?
1. Installing the Actuator onto the Valve Follow the installation instructions in “How to Install the Actuator onto the Valve” to correctly install the actuator on the valve. Confirm normal operation
Miten ON-OFF-sähköventtiili asennetaan?
1. Adjusting the Fine-Tuning Electrical Limit Full Close Adjustment: Use the handle to drive the valve to the fully closed position. Loosen the scale plate locking screw and adjust the scale
Miten toimilaite asennetaan venttiiliin?
Installation Steps Manually rotate the valve to check for any abnormalities and ensure the valve is in the fully closed position. Secure the mounting bracket onto the valve. Fit one end
English (UK) 
香港中文 
繁體中文 
