Tooted

DCL-02

Ülevaade Spetsifikatsioon Dokumendid Video

DCL-02

Ülevaade Spetsifikatsioon Dokumendid Video

Application Circuit

Moduleerimine

E - Modulating with a control unit

Input: 4~20mA / 0~10V
Output: 4~20mA / 0~10V

Connecting Details:

Connecting AC85-220V supply power line to L and neutral to N.
Connecting 4-20mA/2-10V input signal source from control system to input-/+.
Connecting Output -/+ to the system to send out the real-time valve position.

On - Off

A - With 2 active end-position signal outputs

Control actuator to open or close with K
The output terminal of end-position OPEN/CLOSE will send out the event as a 220VAC active signal form when the end-position was reached.

Connecting Details:

Connecting AC85-220V supply power neutral to P1.
Switch AC85-220V line to CLOSE(P2) to close the valve
Switch AC85-220V line to OPEN(P3) to open the valve.
P5 is end-position OPEN terminal which will output a AC220V source which can be used to drive an Indication light when actuator reached end-position of open.
P6 is end-position OPEN terminal which will output a AC220V source which can be used to drive an Indication light when actuator reached end-position of close.
Connect earth to P7.

B - With 2 passive end-position switche

Control actuator to open or close with K
The output terminal of end-position OPEN/CLOSE will send out the event as a passive signal form when the end-position was reached.

Connecting Details:

Connecting AC85-220V supply power neutral to P1.
Switch AC85-220V line to CLOSE(P2) to close the valve
Switch AC85-220V line to OPEN(P3) to open the valve.
P4 is the COM for passive contact signal of end-position OPEN/CLOSE which is normally connected to signal GND.
P5 is end-position OPEN terminal which will be connected to COM when actuator reached end-position of open.
P6 is end-position CLOSE terminal which will be connected to COM when actuator reached end-position of close.
Connect earth to P7.

G - DC motor with 2 end-position switches

Control actuator to open or close by the supply power direction between the terminal 1 and 2
The output terminal of end-position OPEN/CLOSE will send out the event as a passive signal form when the end-position was reached.

Connecting Details:

Connecting DC24V+ to P1 and DC24V- to P2 to close the valve.
Connecting DC24V+ to P2 and DC24V- to P1 to close the valve.
P3 is the COM for passive contact signal of end-position OPEN/CLOSE which is normally connected to signal GND.
P4 is end-position OPEN terminal which will be connected to COM when actuator reached end-position of open.
P5 is end-position CLOSE terminal which will be connected to COM when actuator reached end-position of close.
Connect earth to P7.

25 aastat kogemust vedelike kontrolli alal.

Pühendunud kvaliteetsetele toodetele!

顿汉布什 | dunham-põõsas

多氟多 | DFD

Dünaamiline korporatsioon Limited

©2026 DCL Controls · Privaatsuspoliitika · Saidi kaart · HTML-saidi kaart